Difference between revisions of "Python v2"
From cod3v
| Line 24: | Line 24: | ||
See the SD card settings and instructions from [https://www.ev3dev.org/docs/getting-started/ ev3dev/getting-started] page. | See the SD card settings and instructions from [https://www.ev3dev.org/docs/getting-started/ ev3dev/getting-started] page. | ||
[[Category:Coding]] | [[Category:Coding]] | ||
</translate> | </translate> | ||
Revision as of 12:04, 22 September 2020
Python is a very powerful but programming language for ev3 robots, also.
Programming exercises (only five so far but these will give a solid ground to jump from):
- Steer left and right py v2
- Color sensor readings py v2
- Stop at line py v2
- Line follower Zigzag py v2
- Line follower proportional py v2
The other sensors work similarly; eg. gyroscope sensor py v2 or ultrasonic sensor py v2 (distance meter) are rather easy to employ.
Preliminary things
SD Card
To set ev3dev running you need a SD card which should be made bootable to ev3dev-stretch. The installation (copying) can be made using Etcher.
Connect to your brick. I usually use the USB cable, and it works by plugging.
See the SD card settings and instructions from ev3dev/getting-started page.
